{ "numMessagesInTopic": 5, "nextInTime": 820, "senderId": "qhP0lD2RkXcN4X9PgRHJUDNbQzsNUvw_IdZ5RB2Jho3W2qH1wqPx3uIhqBMDw3KNuTPm7Pbjagw0nQmyXg5b9fD2Kn2nb8c2VbrN", "systemMessage": false, "subject": "RE: [01v96] Setup question", "from": ""Preston" <chendrickson@...>", "authorName": "Preston", "msgSnippet": "thanks, this is good stuff. most of your assumptions are correct. all 13 mics will be used simultainously for the gospel group. we did a test last night with", "msgId": 819, "profile": "prestonhendrickson", "topicId": 806, "spamInfo": { "reason": "0", "isSpam": false }, "replyTo": "LIST", "userId": 129519100, "messageBody": "
> Hey gang, I'm stepping \noutside my box and have agreed to provide
> sound for a conference. \nThe expected attendance is around 400. the
> 100'x38'x14 \n(total of 3,800 sq. ft). You can see the actual floor
> layout \nat
>(http://www.hilton.com/en/hi/hotels/floorplans.jhtml;jsessionid=XMSHOXJ0F
> \nCCSGBIV222QKIYFC5UUC?ctyhocn=DCAOTHF)
>about 1.5ft tall covering the majority of the
> There will be a stage \n
> section marked "salon B" \n(at the back of the room most likely where the
> words "grand \nballroom" is).
>1. 4 speakers -- one at each end of the room (questions: will \n
> I was planning the following:
>
> \n
> delay be necessary?, do I really have to purchase 2 amps to power \nthe
> speakers or is there a way to chain this thing?, if not, \nI'll have to
> main outs for the front speakers and monitor \nouts for the back
> speakers???)Most common speakers you run \nacross are 8 ohm nominal, and
> \n2. stage monitors -- for budget purposes, I'm using 4 yammy msp5 as \n
> stage monitors via omnis 1-4. the biggest thing going on is a \ngospel
> group with about 13 people.Are ya gonna have 13 mics \nup?
> 3. I'm using the \naudix fusion 6 for the drums going through a
> presonus digimax \n(w/limiters), each person has their own mic direct
> board, \nkeys will be direct into the board.
> Any \nideas/suggestions would be helpful on this plan.