{ "numMessagesInTopic": 8, "nextInTime": 2308, "senderId": "do_PTQbH0LBfEMSqFGnDOtDFBWqe6Mk0ZelELBdHc53jv__d8sgPsEA1_p8hgDzCtCw_f7XzOmR_35cZqEredV-k2rbOnpUmwvcaKiSL", "systemMessage": false, "subject": "Re: "CH ERROR" when Transmitting", "from": ""iphone.pavan" <iphone.pavan@...>", "authorName": "iphone.pavan", "msgSnippet": "The old channels in the radio was around 162 mhz and the new channels are around 161 mhz. I programmed this radio earlier with one or two channels and then the", "msgId": 2307, "profile": "iphone.pavan", "topicId": 2304, "spamInfo": { "reason": "3", "isSpam": false }, "replyTo": "LIST", "userId": 528536557, "messageBody": "
--- In GE-Mpa@yahoogroups.com, Walter Howard <walter.howard.jr@...> wrote:
\n>
\n> Was this a working unit before you reprogrammed it?
\n> And you repgrogrammed it with channels near where it was previously
\n> operating? Not just within the stated frequency range, but within the
\n> tuning limits?
\n> When you read the information back from the radio, is it the same as what
\n> you programmed?
\n> Have you ever programmed an MPA before? Or any GE radio?
\n> What's the combination number?
\n> Are you using a KNOWN good battery or a power supply?
\n>
\n>
\n> WalterH
\n>
\n>
\n> On Thu, Jun 6, 2013 at 5:32 AM, iphone.pavan <iphone.pavan@...> wrote:
\n>
\n> > Anyone knows whats the problem when the MPA says "CH ERROR" when i try to
\n> > transmit. The receiving is working good but not the transmitting. And the
\n> > frequencies is programmed within the radios band limits.
\n> >
\n> > After the "CH ERROR" appears it doesn´t go away and the radio gets
\n> > unresponsive, the only solution at this point is to put the radio OFF and
\n> > start it again.
\n> > Any ideas?
\n> >
\n> > Regards.
\n> >
\n> >
\n> >
\n> > ------------------------------------
\n> >
\n> > Yahoo! Groups Links
\n> >
\n> >
\n> >
\n> >
\n>