{ "numMessagesInTopic": 2, "nextInTime": 313, "senderId": "40jh7pCMgLQyyNQaJl91kTfbKoIq-Yd9xyoiDLyqTntfVEtYMOC5-y7mrh3fP0JTHDN8CuApjZrEsCQ4IFYM6jYkXY0NPVLGhm0", "systemMessage": false, "subject": "Re: [GeDeltaRanger] Digest Number 133", "from": ""steve" <steve.m1swb@...>", "authorName": "steve", "msgSnippet": "Thanks Dave yes I thought maybe someone had used this type of setup. I have posted on repeater builder as well, I do have your excellent interfacing the delta,", "msgId": 312, "profile": "stevem1swb", "topicId": 311, "spamInfo": { "reason": "12", "isSpam": false }, "replyTo": "LIST", "userId": 209387736, "messageBody": "
\n\n----- Original Message -----\nFrom: \n Dave Karr\n \nSent: Saturday, February 18, 2006 11:26 \n PM\nSubject: Re: [GeDeltaRanger] Digest \n Number 133\nSteve,
>Hi
>Iam trying to get an nhrc-4 \n controller to work with a Low Band Rangr. I
>have the rx audio going \n into the controller and when I
>tx from another set and send dtmf tones \n the controller led comes
>on OK. The audio out from the controller I \n have going to a small amp. When
>I initialise the controller by \n shorting out JP3 then putting the 12v on, a
>red led comes on for a few \n seconds then goes out, I then remove JP3 and
>send using a dtmf mic \n 1234
>but I don't get the CW OK, and just leaving the controller on \n the
>CW ID isn't sent, any ideas please
Sounds like a controller \n specific question, perhaps posting on the HHRC
list would bring more \n responses.
For interfacing, you might have a look at my Delta Pages \n
<http://www.ka9fur.net/delta/delta.html> \n since the Ranger is essentially a
cost reduced \n Delta-SX.
--Dave, KA9FUR
http://www.ka9fur.net/
\n\n
\n\n No virus found in this incoming message.
Checked by AVG Free \n Edition.
Version: 7.1.375 / Virus Database: 267.15.11/264 - Release Date: \n 17/02/06