{ "numMessagesInTopic": 3, "nextInTime": 1814, "senderId": "BOoMAAywGGrnWi-GhMoJ9W3Hh4_CgdZpAsXorHd_A1GSQ_-CNB7TvGquVVydzg9QxphS1GTgBVco5p2OGcnrxFv0zETbRxeQM0EkUpcs", "systemMessage": false, "subject": "Re: Networking SG20 through Linksys BEFSR81", "from": ""Steve Wilson" <jeff21212002@...>", "authorName": "Steve Wilson", "msgSnippet": "I have a similar setup but I am using a BEFW11S4 Linksys WAP/Router. I simply turned off the software firewall on the Magnia and plugged it into one of the", "msgId": 1813, "profile": "jeff21212002", "topicId": 1812, "spamInfo": { "reason": "0", "isSpam": false }, "replyTo": "LIST", "userId": 111247556, "messageBody": "
> To all,assumptions
\n> I am trying to uplink my SG20 to a Linksys BEFSR81
\n> router/gateway in order to share broadband and of course HD
\n> resources. I will try to explain my circumstances and what I have
\n> done. Please forgive any lack of detail or inappropriate
\n
> (due to ignorance).into
\n>
\n> I use a broadband modem that requires a cross-over cable hooked
\n
> my Lynksys. The Linksys is set to obtain an IP addressautomatically
\n
> and is in "gateway" (as opposed to router) mode with DHCP enabled.uplink
\n>
\n> When I attach the SG20 from the WAN port to either the Linksys
\n
> port with a regular patch cable I can see the SG20 but cannot getto
\n
> the internet. When I attach from the SG20 uplink port to theLinsys
\n
> uplink port I get internet access but cannot see the SG20 on thecan
\n> network. When I use a cross cable and go through regular ports I
\n
> see the SG20 but cannot get to the internet.to
\n>
\n> I wanted to disable NAT translation on the SG20 ut whenever I try
\n
> do so I am told that either the IP address or subnet mask isinvalid
\n
> (all seetings are factory defaults but I have tried both valid IPattempt
\n> addreses and subnets with the same results) and of course my
\n
> to disable NAT fails. A corrupt file maybe?Any
\n>
\n> I am new to Linux and therefore have no idea how to get past the
\n> Toshiba interface. Even if I could I would not know what to do.
\n
> help/advice would be greatly appreciated